Systemic fungicide and plant growth regulator for use on rapeseed crops
Active ingredient: tebuconazole, 250 g/l
Manufacturer: Peters & Burg Ltd, Hungary
Formulation: concentrate emulsion
Packaging unit: canister, 5 l
Mode of action
Tebuconazole — systemic active ingredient, rapidly penetrates into the plant.
As a fungicide. Disrupts the synthesis of ergosterol in pathogen cell membranes. As a result, the membranes of the plant pathogen lose their biological and mechanical properties and the pathogen dies.
As a plant growth regulator. When applied to winter rapeseed crops in autumn, the product slows down the formation of above-ground biomass. At the same time, plastic substances accumulate more intensely, stimulating root and root neck growth, which in turn significantly increases plant winter hardiness.
Application recommendations
The product is applied using ground sprayers at a working solution rate of 200-300 l/ha. In cases of dense plant stands, it is advisable to increase the working solution rate to 400 l/ha to ensure complete and uniform coverage of the plants. The working solution rate should not cause runoff from the plant surface during application.
During application, the buffer zone for bees should be at least 2-3 km, and bee flight time should be limited to 5-6 hours.
Pre-harvest interval from the last application to harvest is 50 days.
Personnel may resume mechanized work 3 days after application.
Crop growth stage
As a growth regulator. Applied in autumn on winter rapeseed when the crop plants have formed 5-7 true leaves.
As a fungicide. Applied preventatively during crop vegetation when conditions favor disease development and spread, or upon appearance of initial visible disease symptoms.
Weather conditions
Rainfall within 6 hours after application does not affect the product's efficacy.
Application is prohibited if wind speed exceeds 4-5 m/s.
Compatibility with other products
The product is compatible with most pesticides and agrochemicals. However, compatibility and phytotoxicity of components in tank mixtures must be tested in each specific case.
Preparation of working solution
To prepare the working solution, fill the sprayer tank with water to half its volume, activate the mixing mode, and add the required amount of product. Fill the sprayer tank with water to full capacity while the mixing mode is active. During application, the mixing mode must remain active to maintain a homogeneous working solution.
