Drip Tape starter with sealing rubber, Dn17/MC 17x8/

Reliable connection without pressure loss

When installing a drip irrigation system over large areas, the tightness of each junction is critical. The Santechplast starter for 17mm Drip Tape with a sealing gasket is the component that saves you from puddles under the main pipe and pressure drops at the end of the row. In field conditions, this solution works reliably: install, tighten, and forget.

Operational features

The main problem with budget fittings is leakage during pressure surges or ground shifts. Here the situation is different: the rubber gasket fits snugly into the hole in the pipe (usually drilled at 14-16 mm) and maintains elasticity even under intense sun exposure. The plastic body does not crack when tightening the nut, which is essential when your hands are dusty and you are working on large-scale acreage.

• Installation: requires no special tools; a quality drill bit and a bit of dexterity are enough.
• Sealing: the rubber gasket covers micro-irregularities at the insertion point.
• Durability: UV resistance allows you to leave the system in the field for the entire season without fear that the plastic will degrade by August.

Maintenance is straightforward: at the end of the season, simply flush the system, loosen the nut, and check the gasket condition. If the water is hard or contains impurities, a filter is mandatory, but the starter itself is resistant to clogging. A pro tip: when installing into the main pipe, do not overtighten the nut—the plastic should operate normally, while the rubber gasket does the heavy lifting for sealing.